XA-Series Air Hydraulic Pump from Enerpac Tool Group - cordless feel, precise 700 bar control

Reviewed: ad hoc news New Release & Launch desk. Edited and checked on 2026-06-23, 04:52. Details in the imprint.

The XA-Series Air Hydraulic Pump from Enerpac sits on the workshop floor with a low, squat stance, its treadle inviting a boot press that brings a quiet hiss instead of a rattling engine. Within seconds, a connected cylinder climbs smoothly toward 700 bar.

Foot-operated power with feel

Enerpac positions the XA-Series as a foot-operated air hydraulic pump for up to 700 bar system pressure, designed for single-acting cylinders and tools in tight industrial spaces. A long treadle lets operators feather the pressure with their boot instead of a hand lever.

Product manager Jack Johnson describes the treadle as a "hands-free trigger" that lets technicians keep both hands on the job while modulating pressure through their foot, especially useful on cramped assembly lines or when aligning heavy flanges during bolting work.

How the XA-Series differs

Compared with classic air-over-hydraulic pumps, the XA-Series integrates an ergonomic design that keeps the operator standing upright, reducing crouching and hand fatigue during long shifts. The body is compact, with a built-in carrying handle and clearly labeled ports.

A built-in pressure relief valve protects against over-pressurization, while an internal air consumption design aims to cut air usage versus older generations, which matters in plants where every cubic meter of compressed air is measured and billed.

In daily industrial use

On a maintenance shift in a steel plant, a technician can park the XA pump beside a flange, connect a single-acting cylinder and route the air hose overhead. The pump stays still on its rubber feet while the treadle takes repeated boot presses without sliding.

Noise is kept relatively low for an air-driven unit, which matters during long days in already loud environments. The pump's tactile response through the treadle helps operators sense when a cylinder meets resistance, rather than relying only on a gauge a few meters away.

Target users and trade-offs

The XA-Series primarily targets industrial maintenance teams, shipyards and construction crews that need 700 bar hydraulic power where electricity is inconvenient or prohibited. Compressed air lines are common in these areas, making an air-driven pump an obvious choice.

The trade-off comes with hose management and the need for a clean air supply. In dusty or damp yards, operators must still protect the air inlet and keep hoses from becoming trip hazards, which means disciplined housekeeping even if the pump itself feels robust.

Share price context and listing

Enerpac Tool Group, the parent behind the XA-Series Air Hydraulic Pump, focuses on high-force tools and solutions for industrial markets worldwide and is listed on the New York Stock Exchange under the ticker EPAC. The Enerpac Tool Group share price trades in US dollars on the NYSE.

This article was AI-assisted and editorially reviewed. Product information without guarantee; prices and availability may change at short notice. No investment advice, no buy or sell recommendation. Stock-market transactions involve risks up to total loss.